The product is mainly used in electronic industry, the product into
clear type and flame retardant. Ambient or heating sulfide. This
product has vulcanization before melt viscosity bottom, facilitate
infusion, vulcanization not exothermic, no low molecular emit
shrinkage small, no corrosion, vulcanizates in - 60 °C --- -250 °C
long-term use under, has moisture-proof, water resistant, weather
resistant radiation-proof, aging etc. Temperature curing, suitable
for mass potting, electric performance is superior.
Main application: used for electronic components potting, adhesive,
coating materials, insulation, since moistureproof, shockproof,
flame retardant functions.
Electronic potting silicone rubber for LED display module Product
It is a kind of low viscosity, Inherent flame resistance, two
components addtion cured potting silicone with heat-conducting. It
cures with both on room temperature and heated temperature. It has
the feature of the higher temperature the faster of the curing
time. It can be applied to electronic components for insulation,
waterproofing, fixed and flame retardant. It mainly applied in
electronic components surface with materials of
PC(Poly-carbonate),PP,ABS,PVC, etc. and metal materials.
Electronic potting silicone rubber for LED display module Typical
It could be applied to
- high powered electronics,
- DC/DC module and circuit board which requires heat dissipation
and high temperature resistance.
-It can be broadly used for LED screen, Wind Power Generator, PCB
Electronic potting silicone rubber for LED display module TECHNICAL
1. Pls put part A and part B in separate container and stir evenly
before mixing the two part together.
2. Mixing Ratio: part A: part B = 1:1
3. Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5
minutes.Then the mixture could be used for pouring.
4. Pls note that the thickness of the silicone affects the curing
time. If the silicone used is a little thick,then the curing time
will be a little longer.The temperature also affects the curing
time.When in lower temperature, we suggest customers appropriately
heat the mixture to accelerate vulcanization. With temperature of
80~100°C, the silicone will cure in 15 minutes; while in 25°C room
temperature, the silicone will cure around 8 hours.
Any questions , please feel free to contact Samuel :